Having broken my front sight blade on my ROA which btw was modified to have a thin post instead of a ramp, I made a replacement out of ali as it was easy to drill a 1.6mm hole in and easy to work on.
But, it also bends easily on filing to shape.
I am now going to make a few out of steel.
My question is: Is the standard ramp profile fine for 25 yard target ? Or should I make a different one?
Mark
Front sight blade profiles.
Moderator: dromia
-
dromia
- Site Admin
- Posts: 20186
- Joined: Sat Nov 06, 2010 4:57 am
- Home club or Range: The Highlands of Scotland. Cycling Proficiency 1964. Felton & District rifle club. Teesdale Pistol and Rifle club.
- Location: Sutherland and Co Durham
- Contact:
Re: Front sight blade profiles.
I'd just make up a dummy fore sight with a strip of can and get it set at the right height for your shooting/load and then make the replacement to that height.
Come on Bambi get some
Imperial Good Metric Bad
Analogue Good Digital Bad
Fecking stones
Real farmers don't need subsidies
Cow's farts matter!
For fine firearms and requisites visit
http://www.pukkabundhooks.com/
-
bigfathairybiker
Re: Front sight blade profiles.
Well, I finally bit the bullet and bought two different height sight blades and had them fitted.
Thanks for suggestion, but it appears my lazyness cells cut in.
Mark
Thanks for suggestion, but it appears my lazyness cells cut in.
Mark
Who is online
Users browsing this forum: No registered users and 1 guest