M3.5 x 10mm metric fine cap head machine screws, 2 needed.

Message

StanDeasy · #11 Post by **StanDeasy** » Thu Aug 02, 2018 9:15 am

I acquired one of these rifles some years ago. It was so accurate I wanted to try it with a scope so I took it into Norman Clark and he machined the dovetail through to the front of the receiver. I think thta's a better option than mounting the front scope ring on the barrel.

#12 Post by **Pete** » Thu Aug 02, 2018 2:02 pm

Thanks for all your replies, Gents..........in view of the problem, StandEasy's approach sounds like my best bet. Although it looks a bit of a tired old dog, I think the rifle's worth it.
Is the receiver likely to have been hardened?

Pete

#13 Post by **snayperskaya** » Thu Aug 02, 2018 5:06 pm

Any good?.......

https://www.accu.co.uk/en/cap-head-scre ... ncQAvD_BwE

#14 Post by **Pete** » Thu Aug 02, 2018 5:52 pm

They would be perfect if they were metric fine, but they're metric coarse, aka just metric.............

Pete

#15 Post by **JSC** » Thu Aug 02, 2018 5:54 pm

I asked in AHC. No luck I'm afraid.

#16 Post by **1066** » Thu Aug 02, 2018 9:33 pm

How about these?

https://www.ebay.co.uk/itm/123510C-Team ... Sw9CVbR2QQ

#17 Post by **Pete** » Fri Aug 03, 2018 2:24 pm

Coarse again......already got some of these.

Pete

The UK's Finest Independent Forum for Shooters and Gun Owners. Est 2010.

M3.5 x 10mm metric fine cap head machine screws, 2 needed.

Re: M3.5 x 10mm metric fine cap head machine screws, 2 neede

Re: M3.5 x 10mm metric fine cap head machine screws, 2 neede

Re: M3.5 x 10mm metric fine cap head machine screws, 2 neede

Re: M3.5 x 10mm metric fine cap head machine screws, 2 neede

Re: M3.5 x 10mm metric fine cap head machine screws, 2 neede

Re: M3.5 x 10mm metric fine cap head machine screws, 2 neede

Re: M3.5 x 10mm metric fine cap head machine screws, 2 neede

Who is online