Hello identifying a powder
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
-
bradaz11
- Full-Bore UK Supporter
- Posts: 4788
- Joined: Mon Jun 02, 2014 1:23 am
- Home club or Range: The tunnel at Charmouth, BWSS
- Location: Bristol
- Contact:
Re: Hello identifying a powder
yep, hence pulling 2 and weighing the powder. if it was more obvious what the powder was, I may have considered it, but these have already all been pulled.
When guns are outlawed, only Outlaws will have guns
-
Blackstuff
- Full-Bore UK Supporter
- Posts: 7839
- Joined: Sun Nov 07, 2010 1:01 pm
- Contact:
Re: Hello identifying a powder
I touched off 50rds worth of 9mm powder from pulled rounds that hadnt been stored properly, just in a small heap and it made what I can only describe as a light-sabre shaped and coloured flame (blue/green/white)! Unfortunately I was standing right over it at the time and with the flame being only about 100mm width but about 1.5m in height i was lucky not to get a face full of it as I jumped out the way!
DVC
Who is online
Users browsing this forum: No registered users and 2 guests