Page 2 of 2
Re: Hello from the Highlands
Posted: Mon Apr 08, 2013 8:08 am
by Yorric
Thanks for all the welcome messages & Hi again to those who already know me - It's good to see y'all on here.
I should be at Cawdor on Sunday - Looking forward to it - especially if it stops snowing!
Ian
Re: Hello from the Highlands
Posted: Fri Apr 12, 2013 6:54 am
by mas36
Welcome aboard. :flag5:
Re: Hello from the Highlands
Posted: Mon May 13, 2013 10:45 pm
by Yorric
Many thanks for the welcome messages all. Glad to be here!
Sandgroper please get in touch - I've had an idea about your bullet/chamber measurements!
Regards Ian
Re: Hello from the Highlands
Posted: Tue May 14, 2013 7:24 am
by Sandgroper
Yorric wrote:Many thanks for the welcome messages all. Glad to be here!
Sandgroper please get in touch - I've had an idea about your bullet/chamber measurements!
Regards Ian
Ian,
You can get me via
postal at sporting-class.com
I've replicated the misfeed - that was down to the COAL.
Re: Hello from the Highlands
Posted: Tue May 14, 2013 8:32 am
by Yorric
Sandgroper
This is what I was trying to describe on Sunday
Make Your Own Length-to-Lands Gauge with a Dremel
Here’s an inexpensive alternative to the Hornady, Stoney Point OAL tool —Make four cuts into the neck of fire-formed, neck sized brass. Then press the bullet in lightly and chamber the entire gauge. As the cartridge chambers, the bullet slides back into the case to give you length to lands. A little light oil in the barrel just past the chamber helps ensure the bullet does not get stuck in the lands. It works great and is very accurate.
Make the cuts using a Dremel with a cut-off wheel. You can adjust tension two ways. First, you can make the cuts longer or shorter. Longer cuts = less tension. If you used only three cuts instead of four you would get more tension. The trick is to be gentle when you open and close the bolt. If you ram the bolt closed you may wedge the bullet into the lands. When you open the bolt it helps to keep a finger or two near by to guide the case out straight because the ejector wants to push it sideways.”
Message to Moderators - Sorry if this is in the wrong section - I'm still finding my way about the forum & couldn't send Sandgroper a personal message.
Ian
Re: Hello from the Highlands - Help request
Posted: Tue May 14, 2013 8:47 am
by Yorric
Message to moderators / Admin
I don't seem to be able to send private messages - When trying to do so, I get a message saying I may be too new on the forum to qualify ??????
Am I being daft & not looking in the right place or is something amiss??
Help please
Ian
Re: Hello from the Highlands
Posted: Tue May 14, 2013 8:50 am
by dromia
You need 15 posts to have full member privileges.
Read the forum Rules sticky in the New Members Welcome forum.
Re: Hello from the Highlands
Posted: Tue May 14, 2013 9:12 am
by Yorric
Thanks Dromia - Will do.