.303 Cast Bullets
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
-
The trakker
Re: .303 Cast Bullets
Ya welocme bud. 'Steve' the savior :lol: , have agood look thru the site, hes worth his weight in gold !
-
Blu
Re: .303 Cast Bullets
Trakker, aye I used to use Steve's pages before, then I had a hard drive crash. Lost all my favourites and Steve's page was one of them and I could never remember the name of the site and no matter what I put in the search engine it never came up. Thanks again mate.
Blu
Blu
-
FilippoMo
Re: .303 Cast Bullets
You should measure the diameter of your bullets and then make a chamber cast of your chambers
and see what the fit is.Bullet diameter should be a close fit to the throating and not groove size.
I wish you a success
Filippo
and see what the fit is.Bullet diameter should be a close fit to the throating and not groove size.
I wish you a success
Filippo
-
dodgyrog
- Posts: 4103
- Joined: Wed Jan 05, 2011 11:17 pm
- Home club or Range: Three Counties Sporting Club & Gardners Guns
- Location: Consett, County Durham
- Contact:
Re: .303 Cast Bullets
Accurate 5744 qo Viht 120 are a good choice.
Persoanlly, I use Viht 140 and push them a bit!!!
Persoanlly, I use Viht 140 and push them a bit!!!
Purveyor of fine cast boolits.
All round good guy and VERY grumpy old man.
All round good guy and VERY grumpy old man.
Re: .303 Cast Bullets
Dodyrog you use N140 for 303 cast bullits I would be intrested to see that recipe.
Re: .303 Cast Bullets
I use around 39.5 grains of N140 behind 174-185 jacketed bullets but keep considering cast as well so I would be interested, especially if you have tried them at longer distances.
Who is online
Users browsing this forum: No registered users and 2 guests