Re: Pin chucks
Posted: Thu Oct 07, 2021 9:46 pm
This is a pin chuck.
All people seeking membership must contact admin after registering to be validated.
https://mail.full-bore.co.uk/
Yes that,s right and they actually worked for my application. Once I was able to find out what they were and how they worked. If you have a Mill they are a doddle to make. I am using them to hold exotic woods and acrylic blanks turned to round with a hole partially drilled leaving a blank end that I can turn to round in the lathe 4 jaw. Using a ball turning tool. (Home made)strangesam wrote: ↑Thu Oct 14, 2021 10:42 pm Doesn't need an angle, if its flat the pin will roll one way with clockwise, and the other with anticlockwise and still jam.