Single shot 9mm UK legal pistol anyone?

[phaedra1106]

And the obvious choice for a suppressed "pistol" ............. 300aac Blackout, nice small cartridge with the ability to perform extremely well with both subsonic (for indoor 25m) and supersonic ammunition.

[Demonic69]

What's the cost like though Phaedra?
I fancy a carbine in 300 Blackout but I reckon it's still quite expensive to buy and reload?

[HALODIN]

For me it all depends on what it looks like and how you reload it.

[DL.]

Oh dear!

I can see what's unfolding here!

http://www.genitron.com/Unique-Handgun/ ... M-2-Pistol

[phaedra1106]

What's the cost like though Phaedra?
I fancy a carbine in 300 Blackout but I reckon it's still quite expensive to buy and reload?

It's actually very cheap, here's my costs for both indoor 25m and outdoor (100-300m)

300 Costs
Re-sized 223 Brass 03p
CCI Primer 03p

Indoor load
3.2g N310 02p
115g RNFP cast boolit 06p

Outdoor Load
16.5g H110 09p
Nosler 168gr Custom Competition bullet 17p

[Sandgroper]

Switch barrel is not an option however I could be persuaded to look at a second barrel/bolt option so you could swap cartridges...

As an aside, Home Office guidance on UK produced firearms require a year of manufacture on the receiver however they do not stipulate the exact nature of the serial, this means I can produce these with customer specific serial numbers if there was sufficient interest.

As an example:
14-MDJ001
14-SGR001

Right now it does not even have a name and is only referred to by the drawing number start sequence which is S145-1

sign01 You're supposed to be making it easier for me to say no to this, rather than harder!

[Stuck]

Oh dear!

I can see what's unfolding here!

http://www.genitron.com/Unique-Handgun/ ... M-2-Pistol

Aye, if it looks like that I'll pass sign01

[Jackmanuk]

What about my little cartridge ( on the right) , i has a .312 bullet in a cut down and sized .223 case

next to it is a 7.62 x 39 and a .223

[Sandgroper]

Might as well use 7.62 Micro Whisper ( or 7.63 Mini Whisper) - basically the same as your case.

[Stuck]

It's just a guess but I would say that wouldn't meet the original spec of something that would shoot cheap factory ammo