Westlake Nitro Muzzle Loading Pistol .38
Posted: Thu Feb 20, 2014 10:47 pm
I have my Nitro muzzle loading pistol in .38 manufactured by Alan Westlake. This is was his flagship model with heavy square target barrel and target rib and light weight target trigger. Comes complete with press, powder (3/4 tub Herco), wad cutters (600+) and over 600 primers. The cylinder was services by Alan last year due to a sticking firing pin which has now been resolved. The overall condition of the pistol is good, there is however some minor cosmetic damage to the cylinder head which was present when I purchased the firearm, this can only seen while the cylinder is split for loading and has no effect on the pistols use at all.
The cost to convert a pistol like this is £550, the target rib is a further £190 before trigger work and cost to buy the pistol in the first place.
This is a complete set-up ready to go for £600 ono. Would consider a swap for either of the following with cash if required.
7.92 K98 Mauser with full original eagle marking and WW2 heritage
7.5mm K31 Schmidt Rubin
.223 Bolt action Varmint rifle with heavy barrel (ideally 1:10/9/8)
.308 bolt action Varmint Rifle with heavy barrel, Remington, Howa, Tikka etc anything which is good for target shooting and with a DM or capable considered
The cost to convert a pistol like this is £550, the target rib is a further £190 before trigger work and cost to buy the pistol in the first place.
This is a complete set-up ready to go for £600 ono. Would consider a swap for either of the following with cash if required.
7.92 K98 Mauser with full original eagle marking and WW2 heritage
7.5mm K31 Schmidt Rubin
.223 Bolt action Varmint rifle with heavy barrel (ideally 1:10/9/8)
.308 bolt action Varmint Rifle with heavy barrel, Remington, Howa, Tikka etc anything which is good for target shooting and with a DM or capable considered