Page 1 of 1
bullet swaging dies
Posted: Thu Jul 23, 2015 10:15 pm
by saddler
Looking into doing some swaging IF I can source dies!
Dies needed are .357 & .45
To fit NALAN CHUNKY if possible, otherwise WAMADET type.
Incomplete sets also of interest...
Re: bullet swaging dies
Posted: Fri Jul 24, 2015 9:46 am
by Marmite5
Are those presses still available?
Re: bullet swaging dies
Posted: Fri Jul 24, 2015 10:22 am
by saddler
Marmite5 wrote:Are those presses still available?
Which presses, Nalan or Wamadet?
I have both....but the former is without dies.
Nalan is still officially trading but I doubt much has been produced in the last 5 years due to Alan's health issues.
Wamadet presses are still sold by Helston's.
Checking out a Wamadet next week in Wolverhampton at an RFD I use....as it has the old original Wamadet swagiing assembly still with it
Re: bullet swaging dies
Posted: Fri Jul 24, 2015 10:32 am
by Marmite5
Ok thanks, saw Alan a a Pheonix meeting a few years back but he did not have a lot on his stall.