Page 1 of 2
Can you ID this stock ?
Posted: Sat May 07, 2011 9:51 pm
by Dave 101
Hi
Can any one ID the maker of this stock ? I bought it on ebay for a project it was listed as a full bore stock , to me it looks like an Anschutz stock , same accessorie rail , same adjustable butt pad , and similar style to smallbore stocks I have seen . Its got a good bit of weight to it , but I think its made of beech due to the cresent shaped marks in the grain , which isnt bad to look at .
Its for a single shot rifle , the barrel groove is 1 1/8" .
Thanks for any ideas .
Dave
Re: Can you ID this stock ?
Posted: Sat May 07, 2011 9:59 pm
by 20series
i would agree, it looks like an Anschutz fullbore stock, but that's a best guess rather than dead cert
Alan
Re: Can you ID this stock ?
Posted: Sat May 07, 2011 10:19 pm
by Robin128
That was my first thought also.
Re: Can you ID this stock ?
Posted: Sun May 08, 2011 8:33 am
by ovenpaa
It could be Anschutz so I agree with that but I am not convinced about it being Beech as going by the pictures the grain looks a bit wide. A very nice looking stock and design though. What is the project going to be?
Re: Can you ID this stock ?
Posted: Sun May 08, 2011 9:14 am
by Dave 101
HI
I have a BRNO model 4 TR with a single shot adapter fitted so it can use a mag as well , same action as the CZ 452 , but with the TR stock there is no access to the mag well , the stock is OK but not my favorite so I thought I would have a go at converting this one .
I have recently put the CZ into an Anschutz stock for use in standing unsupported ,
Dave
Re: Can you ID this stock ?
Posted: Sun May 08, 2011 1:39 pm
by Polchraine
ovenpaa wrote:It could be Anschutz so I agree with that but I am not convinced about it being Beech as going by the pictures the grain looks a bit wide. A very nice looking stock and design though. What is the project going to be?
Almost certainly not beech - it lacks those little flecks that beech always has.
Re: Can you ID this stock ?
Posted: Mon May 09, 2011 5:28 am
by Trident
The stock is for a Musgrave - bedded for a flat bottomed action and 3 bedding screws.
Re: Can you ID this stock ?
Posted: Mon May 09, 2011 5:43 am
by dromia
Welcome to the forum Trident.
Re: Can you ID this stock ?
Posted: Mon May 09, 2011 7:19 am
by ovenpaa
Trident wrote:The stock is for a Musgrave - bedded for a flat bottomed action and 3 bedding screws.
Welcome to the forum Trident, and well identified, you are a TR shooter then?
Re: Can you ID this stock ?
Posted: Mon May 09, 2011 7:24 am
by Christel
Hello Trident,
Welcome to the forum!
Do you know what wood it is?