Page 1 of 1
.357 Brass wanted
Posted: Tue Dec 01, 2015 5:34 pm
by ovenpaa
I am after some .357 brass if anyone still has some spare please, once fired is fine as they will be annealed and necked down for my project 30-357. Ideally need 200-300 however anything is good.
Post here or PM prices is fine.
Re: .357 Brass wanted
Posted: Tue Dec 01, 2015 7:01 pm
by dodgyrog
Go to 7mm and you're very close to 7 x 33 Sako
Re: .357 Brass wanted
Posted: Tue Dec 01, 2015 9:38 pm
by Alpha1
I have got 100 new sellier & belliot .357 cases you are welcome to. I have probably got some fired cases as well. Ill check I'm busy in the middle of a mechanical over all at the moment. Crazy hours. So it will be the week end before I can sort them and get them in the post to you if that's OK.
Re: .357 Brass wanted
Posted: Wed Dec 02, 2015 8:57 am
by ovenpaa
Alpha1 many thanks for your offer, fired cases are fine for what I need at this stage
Re: .357 Brass wanted
Posted: Wed Dec 02, 2015 9:08 am
by WelshShooter
Hi David, I have maybe 40 once fired Gecco range pickup brass and perhaps 100-200 Remington brass. The Gecco is once fired but I think the Remington has been shot 3-4 times (albeit reduced gallery loads) if they are any good for you? I can confirm quantities when I get home tonight.
Re: .357 Brass wanted
Posted: Wed Dec 02, 2015 10:02 pm
by ovenpaa
They sound good to me, this is all for my Aet so they will be necked down hence I am keen to try different makes to see what works best.
Re: .357 Brass wanted
Posted: Wed Dec 02, 2015 11:18 pm
by Alpha1
I have got .357 cases but I'm not sure how many times they have been used Ill have a sort through the boxes in my gun room at the week end and see what I have got.
Re: .357 Brass wanted
Posted: Sat Dec 05, 2015 7:31 pm
by Alpha1
I have definitely got 150 cases that you can have Ill stick them in the post.