The UK's Finest Independent Forum for Shooters and Gun Owners. Est 2010.

Need a set of Steyr SSG 69 26mm Scope rings.
Thanks

Do they have to be actual SSG69 rings or will generic rings to fit an SSG69 be OK? I ask because the original QR ring sets for the SSG69 P1 were numbered to the receiver and the ZFM 6x42Z 'scope is bonded to the rings so originals might be hard to find.

Have a 6X 42 Israeli Photonic scope I want to use which is equivalent to the Kahles ZF 69.
Would like QD rings, but generic would be OK as long as they fit the dovetails in the SSG69 receiver and are 26mm.
Steyr make a slide on Picatinny rail, so that would be and option with 26mm rings, but I want to keep the profile as low as possible.
Thanks

Its a PII by the way

daryldiane wrote:Have a 6X 42 Israeli Photonic scope I want to use which is equivalent to the Kahles ZF 69.
Would like QD rings, but generic would be OK as long as they fit the dovetails in the SSG69 receiver and are 26mm.
Steyr make a slide on Picatinny rail, so that would be and option with 26mm rings, but I want to keep the profile as low as possible.
Thanks

Photonic?
You mean NIMROD....never heard them referred to as the former, always tbe latter.
Will need to check mine as always thought they had inch tubes...

No not Nimrod, I have one of those too it is one inch, I use it on my L1A1.
The Photonic was a kahles zf69 with the same reticule as the Nimrod. Is 26mm unfortunately. Also has depleted tritium illumination.

Been told of a Russian firm making dedicated bases for the SSG....only aboit £25

Do you have any details

Will email him
I know he has a couple of SSG 69's & uses these bases

Found them;
Very helpfull, answered all my questions.
Base slides on and held with grub screws.
Thanks for all your help
http://www.optics-trade.eu/en/mounts/ba ... sg-69.html
http://www.optics-trade.eu/uk/mounts/we ... screw.html