The UK's Finest Independent Forum for Shooters and Gun Owners. Est 2010.

I have a LBP Buckmark with a lightened barrel ,what I want is either a thicker barrel replaced on it or better still a barrel with a fixed moderator .
Is this possible , and how does it work with the section 5 section 1 rulings?
As the moderator is fixed it doesn't need a entry on my FAC does it ?

Any recommendations for doing this ?

Richard Pope at Swift Precision Rifles modded a couple of Buckmarks that my local shop had. Permanently attached moderators do not require a separate variation and the length of them counts towards the overall length of the barrel.

Sim G wrote:Richard Pope at Swift Precision Rifles modded a couple of Buckmarks that my local shop had. Permanently attached moderators do not require a separate variation and the length of them counts towards the overall length of the barrel.

What about barrel weights

I'm presuming you mean as in permanently attached to the barrel and so count towards the overall length? Yes, no different.

Alpha1 wrote:What about barrel weights

Not sure what you mean
weights as an addition ,or the difference in weights of the barrel ?

bump

Posts removed.

Trading is not allowed on the open forum there is a For Sale section for that.

Situations like this should be dealt with of forum via email or PM when eligible.

Sorry, did not mean to break any rules. Just thought it could help two shooters out.

if its lightened then why not just go with a sleeve and turned bar to act as weights

thats how the one I built is done

barrel turned down and light, carbon fibre sleeve, end of barrel screwcut with an endcap for the carbon sleeve

then I had 2 weights, steel bar, od just under id of the carbon tube, bored to suit the od of the reduced barrel, could fit 1 at back, 1 at front or both, as the need or fancy took me