Feeling a bit thick...how does this work?

[falco67]

I'm looking for mould numbered 575213PH which casts a 566 grain bullet and I have seen several places to buy this mould.

But then I came across this with the bottom of the bullet directly under the sprue plate?

So where does the base plug fit?

How does this work?

Or am I looking at it wrong?

regards

Geoff

ps prepared to be embarrassed!

http://imreloading.com/products/lyman-s ... ld-2650213

[dromia]

That is the wrong photo for that mould.

[dromia]

This is the mould you are talking about:

http://www.lymanproducts.com/lyman/bull ... entryID=92


Personally I have never got on with the thick skirted shallow base minies in my Enfields.

[dromia]

Also the Lyman 575213PH is a single cavity only mould.

[falco67]

Hi Adam

I was thinking that I had found a double cavity mould but I can see now that it is wrong. I'm suitably red faced!

I have borrowed a couple of moulds..the ones I used last week came from an unnamed mould that produced 585 grain bullets.

I am currently casting some for this weekend with a mould number PH 58560 that I am told came with the Parker Hale 2 band when it was new..it is casting bullets at 560 grains.

I am open to recommendations where moulds are concerned..is there a mould on the Accurate Molds website that is suitable? There is a lot of choice there!

regards

Geoff

[dromia]

My minie of choice is the RCBS, but have had good luck with the thin skirted Lymans too.

The Lees can be worth a punt as I have found their single cavity HB moulds to work quiet well, just be aware that the Modern Minie "Ash can" mould works well out to 100 yrds or so but drops off accuracy wise after than.

Accurate do not do HB or HP moulds although they will cut you plug cavities for you to have your own plugs made.

I shoot Pritchets in my Enfields now but the cartridges need to be made beforehand and they like base plugs, best to start with a Minie mould and get it shooting good. A bit more instant than Pritchets which can be a labour of love.

I'd be tempted to get a mould that casts the same bullet that did so well for you on last weeks target.