Page 1 of 1
CZ452 varmit scope base.
Posted: Fri Jun 09, 2017 8:20 pm
by Alpha1
Were will I get a dedicated CZ452 varmit scope base weaver/picathingy rail from. Is the trigger kit worth having.
What size is the thread on the barrel that the moderator normally goes on. I need to make a thread protector for it.
Re: CZ452 varmit scope base.
Posted: Fri Jun 09, 2017 9:38 pm
by strangesam
I believe Rimfire Magic might make one.
Re: CZ452 varmit scope base.
Posted: Sat Jun 10, 2017 10:08 am
by kennyc
Alpha1 wrote:Were will I get a dedicated CZ452 varmit scope base weaver/picathingy rail from. Is the trigger kit worth having.
What size is the thread on the barrel that the moderator normally goes on. I need to make a thread protector for it.
normally the thread is /2"UNF and the rails can be found
online I'm told the
spring kits are worth fitting
Re: CZ452 varmit scope base.
Posted: Sun Jun 11, 2017 8:16 pm
by Alpha1
I sorted the end cap it is 1/2"x20 tpi. I also managed to sort out a sight base by modifying some bits I had laid about. So I'm all ready to rock and roll. I will be giving it big licks to morrow evening.
Re: CZ452 varmit scope base.
Posted: Mon Jun 12, 2017 9:36 am
by Kungfugerbil
The trigger kit is absolutely worth looking at. Some include shims, some are just lighter springs. Some folks swear you can use a ballpoint pen spring but if going down that route I would want to throughly bump test after fitting!
For fifteen quid from rimfire magic it's a no brainer to me.
Re: CZ452 varmit scope base.
Posted: Mon Jun 12, 2017 11:22 am
by Alpha1
Thanks I think I will invest in one of the trigger kits.
Re: CZ452 varmit scope base.
Posted: Mon Jun 12, 2017 11:56 am
by glevum
Optics Warehouse do a rail. Check the dovetail size on the rifle before ordering, they vary.
https://opticswarehouse.co.uk/product/r ... inny-rail/
Re: CZ452 varmit scope base.
Posted: Mon Jun 12, 2017 10:35 pm
by Alpha1
The scope base thing is sorted I was able to cobble some thing up from bits I had laid about. The muzzle protector is sorted. I have ordered a trigger kit. I fitted a scope and benched the rifle to night. It shoots really tight groups the eye relief on the scope isn't perfect but I'm sure with a bit of tweaking I can get it right. I was asked at least three times if I was going to fit a moderator. They don't seem to get it. When there questions fell on stony ground the next question was well what about a nice muzzle break. I really do despair.
If they are printing into a tiny ragged hole what difference is a moderator or a muzzle break going to make.
