Page 1 of 1

6.5cm once fired brass.

Posted: Sat Aug 05, 2017 7:40 am
by Pesty
Thanks

Re: 6.5cm once fired brass.

Posted: Sat Aug 05, 2017 8:13 am
by dromia
"cm"??

Re: 6.5cm once fired brass.

Posted: Sat Aug 05, 2017 9:12 am
by BamBam
dromia wrote:"cm"??
creedmoor

Re: 6.5cm once fired brass.

Posted: Sat Aug 05, 2017 9:58 am
by dromia
So its not metrified then, I thought cm meant centi meters.

Re: 6.5cm once fired brass.

Posted: Sat Aug 05, 2017 10:07 am
by kennyc
dromia wrote:So its not metrified then, I thought cm meant centi meters.
on the bright side I bet you would just love to cast some 65mm slugs cheers

Re: 6.5cm once fired brass.

Posted: Sat Aug 05, 2017 11:00 am
by Pesty
Yeah that would be a thing to take down my club not sure my shoulder could take it.

Yes 6.5 creedmore.

Re: 6.5cm once fired brass.

Posted: Sat Aug 05, 2017 4:02 pm
by phaedra1106
Creedmoor not Creedmore, you don't want to get told off for spelling it incorrectly :)

There's the odd lot of once to several times fired Hornady that crop up now and again but it would be cheaper to just fire form some once fired or new 22-250 cases from a decent manufacturer, Lapua, RWS, Norma, Sako etc.

Failing that new are around £100/100 for Lapua, hopefully there may also be StarLine available later this year as they've started making them in both large and small primer versions with the small having the normal .08" flash hole :D

Re: 6.5cm once fired brass.

Posted: Mon Aug 07, 2017 11:39 pm
by Pesty
Will research making 22-250 cases thanks.

Re: 6.5cm once fired brass.

Posted: Tue Aug 08, 2017 7:18 am
by phaedra1106
Run a 6.5 full length sizing die through it, load at the starting end of your powders recommendation, fire, job done.

Just load as normal from then on.