Page 1 of 1
.577 snider reloading
Posted: Tue Apr 10, 2018 6:45 pm
by jay851
Hi
After .577 snider reloading gear
Dies brass bullets moulds etc
Atb
Jay
Re: .577 snider reloading
Posted: Wed Apr 11, 2018 6:50 am
by dodgyrog
I've got two NDFS 577 S cases - used. Any use to you?
Re: .577 snider reloading
Posted: Wed Apr 11, 2018 9:43 am
by FredB
I am shooting the third Snider that I have owned. Never had a set of dies for this calibre. Fill the cases up with the black stuff, plus wad, grease cookie and whatever else you think aids accuracy and pop a bullet on top. Unless your cases are to be used in more than one rifle, there is no need to re size them.
Fred
Re: .577 snider reloading
Posted: Wed Apr 11, 2018 10:11 am
by fra150l
Convert from 24g shotgun brass. That is what I do but you need the dies and they are expensive.
Re: .577 snider reloading
Posted: Wed Apr 11, 2018 10:49 am
by dromia
I have 24 bore new brass is you wish to go that route.
Re: .577 snider reloading
Posted: Wed Apr 11, 2018 10:57 am
by jay851
Anything will help guys thanks. Yes going the 24g magtech route
Atb
Jay
Re: .577 snider reloading
Posted: Wed Apr 11, 2018 11:16 am
by fra150l
You will need to anneal and trim down the brass. If you can get access to a lathe - small mini lathe will make job a lot easier.
I have the Lee dies they are larger than other standard size so check you have press for them. There are others that fit a standard press but they are more expensive.
Re: .577 snider reloading
Posted: Tue Apr 24, 2018 6:22 pm
by jay851
Have now been sorted NDFS .577 snider die set and some brass thanks to dro Mia.
Brass and bullets or moulds still considered.
Re: .577 snider reloading
Posted: Wed Apr 25, 2018 7:27 pm
by mag41uk
I have some ndfs brass I can sell on.
Re: .577 snider reloading
Posted: Thu Apr 26, 2018 5:33 am
by jay851
mag41uk wrote:I have some ndfs brass I can sell on.
Pm sent.