Page 1 of 1
Wanted - a couple of M6 Fine HT cap heads
Posted: Thu Feb 20, 2020 10:36 am
by ovenpaa
I am after a couple of M6 Fine (M6x0,75mm) High Tensile cap head screws although stainless would do at a push. Ideally 12mm long however longer is fine.
These are the same thread as the screws that hold the receiver to the stock on the M54 if you were wondering :)
Re: Wanted - a couple of M6 Fine HT cap heads
Posted: Sun Mar 01, 2020 12:19 pm
by Dark Skies
Re: Wanted - a couple of M6 Fine HT cap heads
Posted: Sun Mar 01, 2020 1:39 pm
by artiglio
Only place i could find them was from china via the auction site, did have a couple of spare i’ll see if i can dig them out.
Re: Wanted - a couple of M6 Fine HT cap heads
Posted: Sun Mar 01, 2020 1:49 pm
by ovenpaa
They don't appear to stock M6 Fine.
Re: Wanted - a couple of M6 Fine HT cap heads
Posted: Sun Mar 01, 2020 2:00 pm
by ovenpaa
Phil, that would be handy if you can put your hands on a couple. I have ordered some from HK however they are going to be a couple of weeks away at least...
Re: Wanted - a couple of M6 Fine HT cap heads
Posted: Sun Mar 01, 2020 2:42 pm
by Polchraine
M6x0.75 did not sound like a thread I was aware of, so I had look around and found that M6 can have:. 0.5. 0.7. 0.75. 0.80 or 1.0 pitch ...
https://www.engineersedge.com/hardware/ ... sizes1.htm