Page 1 of 1
MDT LSS - 22 - screw thread?
Posted: Sun May 30, 2021 6:35 pm
by Geek
MDT LSS - 22 (Ruger American)
Do any of you know the thread of the screws on the underside of an MDT LSS – 22 (gen 1) chassis? I would like to fit a front rest rider. I asked the the company (UK based) where I purchased it and they advised 10-32" UNF, however, after purchasing the screws (via Amazon), they don’t fit! Therefore, anyone know the answer?
Any assistance much appreciated.
Thank you
Re: MDT LSS - 22 - screw thread?
Posted: Mon May 31, 2021 2:46 pm
by ovenpaa
Were they too big/too small or close but wrong pitch?
Re: MDT LSS - 22 - screw thread?
Posted: Mon May 31, 2021 5:48 pm
by Geek
They went in about half a turn then stopped.
Re: MDT LSS - 22 - screw thread?
Posted: Mon May 31, 2021 9:39 pm
by ovenpaa
M5 screws maybe then?
Re: MDT LSS - 22 - screw thread?
Posted: Tue Jun 01, 2021 10:00 am
by X2001xr
So the screws that are supplied are 10/24 flat head screws in ½” length.
Re: MDT LSS - 22 - screw thread?
Posted: Tue Jun 01, 2021 5:05 pm
by Geek
I have asked another RFD and they don't know for sure, but could be 8 -32 or 8 - 36. Their advise was to contact MDT, which I was going to do but couldn't find a contact e-mail address.
Re: MDT LSS - 22 - screw thread?
Posted: Tue Jun 01, 2021 5:26 pm
by glevum
If you have a 3.5mm drill bit, you could try to see if the shank fits in the hole.
If it fits, it is probably 10-24
Re: MDT LSS - 22 - screw thread?
Posted: Sun Jun 06, 2021 12:22 pm
by phaedra1106
There's a direct contact point on their website,
https://support.mdttac.com/hc/en-us
Last email I had from them came from
support@mdttac.com
Re: MDT LSS - 22 - screw thread?
Posted: Sun Jun 06, 2021 2:22 pm
by Geek
Thank you