Page 1 of 1
Harris Bipod foot spring
Posted: Sat Sep 08, 2012 2:44 pm
by TattooedGun
I bought a Harris today from a guy at my rifle club, but he had modified one leg so he could cant the rifle on the bipod.
I want to put it back to standard so I need a spring and some roll pins, does anyone have a spare spring lying around? Or know where I could get hold of one?
Thanks in advance!
TG
Re: Harris Bipod foot spring
Posted: Mon Sep 17, 2012 9:57 am
by TattooedGun
No-one dismantled a Harris and changed the feet with parts left over? or know where I could find one? :(
Re: Harris Bipod foot spring
Posted: Mon Sep 17, 2012 10:10 am
by Meaty
Hello,
I have access to all sorts of springs-if you could send me some dimensions of what you are after, I can have a look around and get something off to you. I have roll pins etc as well
Re: Harris Bipod foot spring
Posted: Mon Sep 17, 2012 10:31 am
by ovenpaa
I have one in bits right now as I am building a run of replacement feet, I will try and get some dimensions and a picture up in a bit..
Re: Harris Bipod foot spring
Posted: Mon Sep 17, 2012 6:44 pm
by TattooedGun
ovenpaa wrote:I have one in bits right now as I am building a run of replacement feet, I will try and get some dimensions and a picture up in a bit..
That would be awesome! saves me taking the other side apart and losing bits! :) Thankyou both! :)
Re: Harris Bipod foot spring
Posted: Mon Sep 17, 2012 7:19 pm
by ovenpaa
I will add some dimensions in a bit.
Re: Harris Bipod foot spring
Posted: Mon Sep 17, 2012 7:25 pm
by ovenpaa
Roll pin .127" Diameter x .879" So it is a standard 1/8" x 7/8" roll pin
Spring Free length is 5/8" x .485" OD and .041" wire thickness, it has a slight taper on it. If you get stuck I can wind you one.