Really! Who'd have thought people would waste their money!dromia wrote:You mean you can buy them ready made? :shock:
Reloading Poll
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
-
dodgyrog
- Posts: 4103
- Joined: Wed Jan 05, 2011 11:17 pm
- Home club or Range: Three Counties Sporting Club & Gardners Guns
- Location: Consett, County Durham
- Contact:
Re: Reloading Poll
Purveyor of fine cast boolits.
All round good guy and VERY grumpy old man.
All round good guy and VERY grumpy old man.
-
John25
Re: Reloading Poll
Mike357 wrote:I am just about to dip my toe into reloading, firstly 357 Mag, then on to 303/308. Need to sort out my Man Cave first then I'm good to go!
I am bricking it quite frankly :shock: :shock: :shock: :shock:
Follow the book, do everything in stages, then double check.
Don't get distracted, no radio etc.
Work up a load suitable for your gun, maximum measures are often not the best for you.
You'll get hooked and you will never have enough reloading kit!
(Says he after two orders to Midway this month! - well I need lube, new top punch, lead dipper - trod on the old one etc. etc.)
One piece of advice, don't reload for someone else and don't use someone else's hand loads.
Re: Reloading Poll
I reload 12g slug and mould my own slug. It's taken me a while to reach the point of that will cycle reliably in a semi-auto. On my last test a few weeks ago it was pleasing to find that my loads cycled more reliably than the manufactured stuff I had.
I'm just saving my pennies up now but I shall be starting on .38/.357 in the next couple of months and hope to get comfortable enough with that by the end of the year to move on to .303 and then 7.5x55.
Paul.
I'm just saving my pennies up now but I shall be starting on .38/.357 in the next couple of months and hope to get comfortable enough with that by the end of the year to move on to .303 and then 7.5x55.
Paul.
Re: Reloading Poll
...and I am about to put some cast boolits through my 4(T) something new to me, I only have a couple of .303's so I am not convinced the investment in equipment to feed cast into them is necessary at this moment, I need to investigate further 
Who is online
Users browsing this forum: No registered users and 4 guests