ATI shotgun stocks

[38Super]

As above. ATI T3 or Shotforce

Anyone have any experience of these.

I'm trying to put together a 12g pump with 12" to 13" length of pull and just looking at options.

Other options I've found are the Magpul shotgun stock or (possibly) Hatsan Youth/Lady stock if they can be fitted to a 12g receiver.
Failing all else I could get the hacksaw out but I'd like that to be a last resort.

[Gazza]

I put a T3 on my stoeger with a bit of fettling to get the LOP right down as I'm a short arse
A lot of money for what is a lot of plastic bits but it's the only way I could get this gun comfortable.
It's not meant to fit a stoeger hence the fettling.

https://www.full-bore.co.uk/viewtopic.p ... eger+stock

[Dellboy]

I put a T3 on my stoeger with a bit of fettling to get the LOP right down as I'm a short arse
A lot of money for what is a lot of plastic bits but it's the only way I could get this gun comfortable.
It's not meant to fit a stoeger hence the fettling.

https://www.full-bore.co.uk/viewtopic.p ... eger+stock

you are a clever bar steward then . are they ok i fancy a big capacity auto ...

[Gazza]

For a budget benelli rip off they are ok Dell.
They are hard work in standard form if your vertically challenged but most semis are, well, to me they are

[38Super]

That's a very neat fitting job you've done there.

There are plenty of high capacity shotguns around it's the short LOP that is much more difficult.
Did the T3 stock give you the correct sight picture? I've seen some comments saying that it's too high. Designed for iron sights or a scope apparently.

[Dellboy]

For a budget benelli rip off they are ok Dell.
They are hard work in standard form if your vertically challenged but most semis are, well, to me they are

you mean not abnormally tall

[Gazza]

That's a very neat fitting job you've done there.

There are plenty of high capacity shotguns around it's the short LOP that is much more difficult.
Did the T3 stock give you the correct sight picture? I've seen some comments saying that it's too high. Designed for iron sights or a scope apparently.

The sight picture improved dramatically (for me) so it was an all round good mod.
The T3 comes with around 6 adapters to fit the common pumps/semis from what I remember one of which fits the stoeger nicely.
I could do with shortening the stock tube now to lose another half inch or so but from what I remember it's not that straight forward.
This might be a winter garage project.
A 10/11 shot semi is real good fun for clays when you can have a few traps firing at the same time

[38Super]

The sight picture improved dramatically (for me) so it was an all round good mod.
The T3 comes with around 6 adapters to fit the common pumps/semis from what I remember one of which fits the stoeger nicely.
I could do with shortening the stock tube now to lose another half inch or so but from what I remember it's not that straight forward.
This might be a winter garage project.
A 10/11 shot semi is real good fun for clays when you can have a few traps firing at the same time

I'm after something for PSG with an 8 shot tube minimum.
The ShotForce version (without the padded grip) appears to have a thinner butt pad and goes down to a 12.25 inches. Quite a bit cheaper too.
How do you find the pistol grip on yours? I read that some people find it too big for small hands.

[Gazza]

The pistol grip is chunky but ok