Magtech primers

This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.

Moderator: dromia

Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.

Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Message
Author
User avatar
Graham M
Full-Bore UK Supporter
Posts: 994
Joined: Sun Nov 07, 2010 1:14 pm
Location: Brum
Contact:

Re: Magtech primers

#11 Post by Graham M »

Hope they are non-toxic ball bearings
Never argue with an idiot, he will drag you down to his level and beat you with experience.
Scrumbag
Posts: 91
Joined: Wed Jul 29, 2020 3:45 pm
Home club or Range: BSRC & HPRPC
Contact:

Re: Magtech primers

#12 Post by Scrumbag »

Used with good results in Large Rifle and Small Rifle though better for stick powders in small rifle rather than ball.

(Found TAC and X-Terminator did better with a bit more kick from a CCI 450 in my .223 Rem especially with 55gr loads).

Scrummy
Post Reply

Who is online

Users browsing this forum: Google [Bot] and 0 guests