Had a Loadmaster, had 2 in fact! too much faffing and tweaking to get them to run smoothly.
I've now got 4 of the newer Auto Breech Lock Pro's
Feed them with primed cases as the lee primer holders are pants, powder drop, neck expand (where needed) bullet seat then factory crimp.
One for 44Mag, one for 300BLK indoor loads, one for 300BLK outdoor loads and one for 308 "not serious target" ammo, still 1 MOA (or less) at 100yds though.
Progressively reloading 44 mag / spc
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
-
phaedra1106
- Posts: 3428
- Joined: Wed Feb 08, 2012 9:37 pm
- Location: Just outside Sacriston (the nice bit!)
- Contact:
Re: Progressively reloading 44 mag / spc
There's room for all Gods creatures, next to the mash and gravy :)
-
bradaz11
- Full-Bore UK Supporter
- Posts: 4788
- Joined: Mon Jun 02, 2014 1:23 am
- Home club or Range: The tunnel at Charmouth, BWSS
- Location: Bristol
- Contact:
Re: Progressively reloading 44 mag / spc
you know you want to make it 5 of them....phaedra1106 wrote: ↑Wed Feb 05, 2025 8:28 pm Had a Loadmaster, had 2 in fact! too much faffing and tweaking to get them to run smoothly.
I've now got 4 of the newer Auto Breech Lock Pro's
Feed them with primed cases as the lee primer holders are pants, powder drop, neck expand (where needed) bullet seat then factory crimp.
One for 44Mag, one for 300BLK indoor loads, one for 300BLK outdoor loads and one for 308 "not serious target" ammo, still 1 MOA (or less) at 100yds though.
When guns are outlawed, only Outlaws will have guns
Who is online
Users browsing this forum: No registered users and 3 guests