The UK's Finest Independent Forum for Shooters and Gun Owners. Est 2010.

apologies for putting this in the wrong forum ( reloading ) I'm looking to put a muzzle brake on my RPR 6.5CM, need some advice on which one and a dealer.

Something like this from Spud

Personally with the 6.5C I wouldn't bother, it's got very little recoil due to the straight line geometry of the design.

This will work, seen a few used in the Precision Rifle Series on 6.5CM rifles.

http://www.lannertactical.com/tactical1/DGN762B.html

BamBam wrote:This will work, seen a few used in the Precision Rifle Series on 6.5CM rifles.

http://www.lannertactical.com/tactical1/DGN762B.html

I asked about one of these for my Ruger PR (6.5CM) and was advised that they didn't have anything suitable.

old_n07 wrote:Something like this from Spud

I bought one of these for my Ruger PR (6.5CM) from here http://www.valmontfirearms.co.uk/rugerrifles.html (£100+p&p), in my opinion a worthwhile investment.

However firstly if a gen 1 have you changed the bolt shroud? I purchased this https://www.riflecraft.co.uk/titanium-bolt-shroud

Hi geek, yes I changed my shroud as the plastic one cracked , I bought an aluminium one and had nothing but trouble , as the rounds would hang fire until I slightly touch the magazine or bolt handle, then they would fire , the shroud had not been machined to the proper specs...so beware, I use my crack plastic one or without a shroud, I have a gen 1, will look at that muzzle brake though

Try here
https://store-4nhhn.mybigcommerce.com/c ... 0bd2978b3b