Where can I get a thread protector in M24 x 1.5mm RH thread?
Posted: Sat Aug 26, 2017 2:07 pm
I need a thread protector in M24 x 1.5mm RH thread for my Saiga AK74-alike.
K-VAR do an excellent one currently going for under $8 part # AK-040B
Obviously though they won't sell something so dangerous outside of the USA.
I could just chop down my muzzle brake but that's a tad drastic. Also if I want to sell it on the prospective buyer would want it intact.
I could buy a cheap one and chop that down but again, they're all in America so see above.
It's getting silly now. I'd even settle for a pipe insert / pipe joiner.
I looked at buying a tap to make my own out of a bit of pipe but they're around the £25 mark which seems a bit over the top for one job.
Anyone know where I might source one?
K-VAR do an excellent one currently going for under $8 part # AK-040B
Obviously though they won't sell something so dangerous outside of the USA.
I could just chop down my muzzle brake but that's a tad drastic. Also if I want to sell it on the prospective buyer would want it intact.
I could buy a cheap one and chop that down but again, they're all in America so see above.
It's getting silly now. I'd even settle for a pipe insert / pipe joiner.
I looked at buying a tap to make my own out of a bit of pipe but they're around the £25 mark which seems a bit over the top for one job.
Anyone know where I might source one?