Shotgun re-loading

This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.

Moderator: dromia

Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.

Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Post Reply
Message
Author
User avatar
Graham M
Full-Bore UK Supporter
Posts: 1010
Joined: Sun Nov 07, 2010 1:14 pm
Location: Brum
Contact:
Contact Graham M

Shotgun re-loading

#1 Post by Graham M »

Right, here's a question for you shot-shell re-loaders out there. I have acquired a couple of reloading presses including a gert Texan progressive press.
Texan press.jpg



Not going to be using this as it's a bit too much at the moment, but will be using a nice Redding single stage one.
Redding press.jpg

No problem I thought until I went onto a re-loading site to have a mooch and was a bit taken aback at the number and types of primers, wads and over powder cards etc.
Anyone out their know what the simplest components to use would be for someone just about to dip their toe into this type of re-loading. any????
Never argue with an idiot, he will drag you down to his level and beat you with experience.
Top
User avatar
Graham M
Full-Bore UK Supporter
Posts: 1010
Joined: Sun Nov 07, 2010 1:14 pm
Location: Brum
Contact:
Contact Graham M

Re: Shotgun re-loading

#2 Post by Graham M »

Will be reloading 70mm 1oz loads fibre wads.
Never argue with an idiot, he will drag you down to his level and beat you with experience.
Top
BooBoo
Posts: 122
Joined: Mon Jan 30, 2017 9:37 pm
Home club or Range: Various
Contact:
Contact BooBoo

Re: Shotgun re-loading

#3 Post by BooBoo »

I would suggest that you take a look at the sample loads page on the FES website. That said, you'll now struggle to get hold of Maxam powders... John may assist with alternatives.

BPI publish data for euro components coupled with common US powders. However, you'll also now struggle to get hold of those as well.

Good luck with your hunt.
Top
User avatar
Blackstuff
Full-Bore UK Supporter
Posts: 7839
Joined: Sun Nov 07, 2010 1:01 pm
Contact:
Contact Blackstuff

Re: Shotgun re-loading

#4 Post by Blackstuff »

If you use Facebook there are a number of shotgun reloading pages on there which i've found helpful. Although i do load my own slug and buckshot i'm still using plas-wads as reloading birdshot hasn't YET become economically viable (not far off).

But with the impending lead ban i'm not investing any more time or energy into anything reloading until the outcome comes through as it may all be moot :bad:
DVC
Top
Post Reply

Return to “Reloading and Ammunition”

Who is online

Users browsing this forum: No registered users and 1 guest