Loading Stand for Remington 1858

[qws]

I am looking for a loading stand to speed up my loading of the Remington 1858 I have. It is a Nitro conversion from Anvil. I have seen them on sites from the USA - even eBay UK but will not ship to the Uk. Does anyone have one for sale or know a Uk source. I know I could make one but my woodworking skills - just ask the wife it's no no.

[Christel]

Stab in the dark...

http://www.henrykrank.com/index.php?mai ... cts_id=267

[qws]

Hi Seen this, but I do not remove the cylinder to reload. So need a stand that allows the whole revolver to sit upright with exposed powder chambers.

[ovenpaa]

The ones I have seen are usually a hardwood such as Oak so reasonable to work with, have you considered making one yourself?

[qws]

The ones I have seen are usually a hardwood such as Oak so reasonable to work with, have you considered making one yourself?

Yes but I have no skill, started to level legs on a chair it ended up only 1" off the floor ???
I have seen one of the web in Oak only £15.00 but cannot find it any more.

[Christel]

apologies

[Dellboy]

i use the Krank one makes life far easier ,seen the full gun stand in use and looked a pain actually

[dromia]

Have you tried using the stand you are on about?

I find it far easier to load without such added complications, my revolvers and pistols stand muzzle up quiet happily against the lid of my range box and when it comes to using the rammer I find it far easier to use holding the revolver in my hand rather than jiggling with a stand.

[falco67]

I'm not proud of this, as you can see I am not a carpenter, aaarggh but it works. I was going to make a better one, but why bother, it wouldn't be any better!

[qws]

Looking good,as long as it works why change it